Maintenance
Preventive Maintenance
40 MagneMotion
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Wheeled Puck Cleaning
The wheeled pucks that are used on the MagneMover LITE transport system may require
cleaning to remove any particulate buildup on the wear surfaces of the pucks.
Required Tools and Equipment
• Disposable gloves.
• Microfiber cleaning cloth.
• Deionized water.
• Isopropyl alcohol.
Procedure
1. Remove the wheeled puck from the MagneMover LITE transport system (see Replace
Pucks on page 78).
2. Wear gloves and clean the rolling surface of all wheels with clean cotton tipped swabs
slightly dampened with Isopropyl alcohol (squeezing the swab should not cause any
alcohol to drip) by running the swab over the surface in a back-and-forth motion in the
direction of travel (see Figure 8).
Figure 8: Wheeled Puck Cleaning
3. Wear gloves and clean external puck surfaces with a clean microfiber cloth slightly
dampened with Isopropyl alcohol (squeezing the cloth should not cause any alcohol to
drip) by running the cloth over the surfaces in the direction of travel (see Figure 8).
4. Wear gloves and dry all cleaned puck surfaces with a clean, dry, cotton tipped swab,
and a clean dry microfiber cloth.
5. Replace the puck on the MM LITE transport system (see Replace Pucks on page 78).
Puck Body
Magnet Array
Lateral Guide
Wheels
Suspension
Wheels
Direction of Travel
Septum Wheels
(if supplied)
To Next Page
Loading...
