Rockwell Automation MagneMotion MagneMover LITE Service Manual

Maintenance
Preventive Maintenance
MagneMover LITE Service Manual 39
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Glide Puck Cleaning
The glide pucks that are used on the MagneMover LITE transport system may require clean-
ing to remove any particulate buildup on the wear surfaces of the pucks.
Required Tools and Equipment
• Disposable gloves.
• Microfiber cleaning cloth.
• Deionized water.
• Isopropyl alcohol.
Procedure
1. Remove the glide puck from the MagneMover LITE transport system (see Replace
Pucks on page 78).
2. Wear gloves and clean internal puck wear surfaces with a clean, cotton tipped swab
slightly dampened with Isopropyl alcohol by running the swab between the top and
center plates with a back-and-forth motion in the direction of travel (see Figure 7).
Figure 7: Glide Puck Cleaning
3. Wear gloves and clean external puck wear surfaces with a clean microfiber cloth
slightly dampened with Isopropyl alcohol by running the cloth over the surfaces in the
direction of travel (see Figure 7).
4. Wear gloves and dry all cleaned puck surfaces with a clean, dry, cotton tipped swab,
and a clean dry microfiber cloth.
5. Replace the puck on the MM LITE transport system (see Replace Pucks on page 78).
Internal Wear
External Wear
Surfaces
Surfaces

Rockwell Automation MagneMotion MagneMover LITE Specifications

General

Brand	Rockwell Automation
Model	MagneMotion MagneMover LITE
Category	Accessories
Language	English