Rodgers 702 - To Send a Variation Select and Program Change Message

• To Send A Variation Select And Program Change Message From A MIDI Coupler:
1. Hold SET.
2. Press and hold selected MIDI coupler (coupler will flash as
it is held).
3. Release SET and press key which corresponds to the variation desired:
Low C (Great)
Low C# (Great)
Low D (Great)
etc.
Low C (Swell)
Low C# (Swell)
etc.
Low C (Pedal)
Low C# (Pedal)
etc.
Low
F (Pedal)
Variation
0
Variation 1
Variation 2
Variation 61
Variation 62
Variation 122
Variation 123
Variation 127
4. After Variation is selected, release MIDI coupler
(it will continue to flash).
5. Press key which corresponds to the Program Change desired:
Low C (Great) Program Change
1
Low C# (Great) Program Change 2
Low D (Great) Program Change 3
etc.
Low C (Swell) Program Change 62
Low
C# (Swell) Program Change 63
etc.
Low C (Pedal) Program Change 123
Low C# (Pedal) Program Change 124
etc.
Low F (Pedal) Program Change 128
If no Variation Select message is specified, Variation 0 will be used.
Pressing General Cancel at any time during will exit the procedure.
RECEIVING PROGRAM CHANGES
AND GS VARIATION SELECT CHANGES FROM A PR-300
When in a MIDI set Mode, if a Program Change or a Variation Select on the MIDI Channel for
the flashing coupler is received, it will be saved and retransmitted each time the coupler is turned
on.
15