SAVING A COMBINATION MEMORY
The contents
of
any combination memory may be saved into a MIDI sequencer and later
reloaded into the organ.
•
To
Save A Memory:
1.
The Master Clock
on
the sequencer must be ON.
2.
Select the memory to be saved.
3.
Hold
SET. Start the sequencer, and wait for
it
to begin recording.
4. Release SET to begin the transmission
of
memory information. Each piston will light as
it
is
saved to the sequencer.
5. Stop the sequencer after all pistons have been saved.
•
To
Restore A Memory
From
The Sequencer:
1.
Select the memory to be loaded into the 702.
2.
Hold
SET and start the sequencer playback. Each piston will light as
it
receives memory
information.
3. Release
SET
after the final memory has been received.
RECEIVING A PROGRAM CHANGE
Registrations may be selected on the organ by sending a Program Change from another MIDI
device. The following is a list
of
Program Changes the 702 will respond to
on
Channel 12:
16
Program Change
1
2
3
4
5
6
7
8
9
10
20
21
22
23
24
Will Select
General piston 1
General piston 2
General piston 3
General piston 4
General piston 5
General piston 6
General piston 7
General piston 8
General piston 9
General piston 10
General Cancel
Great Divisional piston 1
Great Divisional piston 2
Great Divisional piston 3
Great Divisional piston 4
Program Change
25
26
Channel 13:
21
22
23
24
25
26
Channel 14:
21
22
23
Will Select
Great Divisional piston 5
Great Divisional piston 6
Swell Divisional piston 1
Swell Divisional piston 2
Swell Divisional piston 3
Swell Divisional piston 4
Swell Divisional piston 5
Swell Divisional piston 6
Pedal Divisional piston 1
Pedal Divisional piston 2
Pedal Divisional piston 3
To Next Page
Loading...
