PR311 v1.0 fv102 EN Rev.E.DOC 10/22/2007
15
[11#] [MASTER] [NNN] [Card] – Program a new card for the user ID=NNN
The card presented to a unit will be assigned to the user with ID=NNN.
[12#] [MASTER] [NNN] [PIN] – Program a new PIN for the user ID=NNN
The entered PIN will be assigned to the user with ID=NNN.
[13#] [MASTER] [NNN] – Remove user with ID=NNN from memory
The user with ID=NNN will be removed from memory.
[14#] [MASTER] [NNN] – Check if ID number is not occupied
If the location of memory assigned for the user with ID=NNN is free (it means that neither card nor PIN has not
been defined yet) the unit generates (OK) signal, when either card or PIN has been already defined to an
ID=NNN location the unit generates (Error) signal.
[17#] [MASTER] [17] – Remove all users from memory
All cards and PINs will be erased; all IDs will be released and enabled for new cards and PINs.
[21#] [MASTER] [NNN] [Card] – Program a new card for the user ID=NNN with WA privilege
The card presented to a unit will be assigned to the user with ID=NNN, the user has an AWA privilege; user
may enter the room when controller is Armed.
[22#] [MASTER] [NNN] [PIN] – Program a new PIN for the user ID=NNN with AWA privilege
The entered PIN will be assigned to the user with ID=NNN, the user has an AWA privilege; he/she may enter
the room when controller is Armed.
[31#] [MASTER] [F] – AUX1 flag control command
This command enables control of AUX1 flag, depending on [F] value the AUX1 can be set, cleared or toggled to
opposite condition.
When [F]=[0] the AUX1 flag will be cleared,
When [F]=[1] the AUX1 flag will be set,
When [F]=[2] the AUX1 flag will be toggled to inverse condition.
[33#] [MASTER] [F] – LIGHT flag control command
This command enables control of LIGHT flag, depending on [F] value the LIGHT can be set, cleared or toggled
to opposite condition.
When [F]=[0] the LIGHT flag will be cleared,
When [F]=[1] the LIGHT flag will be set,
When [F]=[2] the LIGHT flag will be toggled to inverse condition,
[34#] [MASTER] [T] – Door Mode control command
This command enables to change the Door Mode of the controller; the [D] value specifies requested Door
Mode.
When [D]=[0] the door will be set to Normal mode,
When [D]=[1] the door will be set to Unlocked mode,
When [D]=[2] the door will be set to Conditional Unlocked mode,
When [D]=[3] the door will be set to Locked mode.
[35#] [MASTER] [I] – Identification Mode control command
This command enables to change the Identification Mode of the controller, the [I] value specifies requested
Identification Mode.
When [I]=[0] the Identification Mode will be set to Card or PIN,
When [I]=[1] the Identification Mode will be set to Card only,
When [I]=[2] the Identification Mode will be set to PIN only,
When [I]=[3] the Identification Mode will be set to Card and PIN.
Note: Each user ID index consists always of three digits to form ID numbers ranging 000–999.
To Next Page
Loading...
