Interfaces and Connectors
R&S
®
SFE100
21Getting Started 2112.4122.62 ─ 13
5.2 Rear Panel
This chapter provides an overview of the controls and connectors on the rear panel.
Each control or connector is briefly described along with a reference to the chapter(s)
containing detailed information about its usage.
5.2.1 AC Power Supply Connector and Switch
The IEC 320 / EN 60320 AC power supply connector and the AC power switch are
combined (type C14).
A fuse holder is integrated.
The AC power switch is located on the right of the AC power connector.
Switch positions:
●
I: The R&S SFE100 is in operation.
●
O: The entire instrument is disconnected from the AC power supply.
For further information:
●
See Chapter 11.2, "Replacing the Fuses", on page
58
●
See Chapter 6.2, "Connecting to the AC Power Supply", on page 28
●
See Chapter 7, "Switching On or Off the R&S SFE100", on page 33
5.2.2 TS1 IN / TS2 IN
BNC connector. Used to feed in a serial MPEG2 transport stream.
These inputs handle a serial signal with one of three formats:
●
ASI (asynchronous serial interface)
●
SMPTE 310 (Society of Motion Picture and Television Engineers)
●
ETI (TS2 IN only)
To select the input, select
"DIGITAL TV"
menu, "INPUT SIGNAL", "INPUT". For further
details see the user manual or the help system.
Rear Panel
To Next Page
Loading...
