Interfaces and Connectors
R&S
®
SFE100
22Getting Started 2112.4122.62 ─ 13
For the T-DMB / DAB transmission standard, TS2 IN is used as an external ETI input
(ensemble transport interface). TS1 IN is not used for T-DMB/DAB. TS2 IN is conform
to the ETS 300 799 specification. ETI NI (network independent) and ETI NA 5592 or
ETI NA 5376 (network adaptation) signals are accepted.
5.2.3 VIDEO IN
BNC connector. Video input for the ATV transmission standards.
5.2.4 AUDIO AUX
9 pin SUB-D connector for multi purpose input.
●
Audio IN
●
BTSC IN
●
NICAM IN
●
REF FREQ OUT / Trigger OUT
A signal is present on the reference frequency output pin (TRIG / REF OUT) if it is
activated.
For further details see user manual or the help system.
When using an internal reference, the frequency generated by the internal refer-
ence oscillator of the R&S SFE100 is made available. If an external reference is
activated, the signal applied to REF IN is also available on REF OUT pin. It is buf-
fered and filtered.
Rear Panel
To Next Page
Loading...
