Installed Software
R&S
®
SFE100
50Getting Started 2112.4122.62 ─ 13
10.1.2 Windows XP Start Menu
The Windows XP Start menu provides access to the Windows XP functionality and
installed programs. Under "Control Panel"
, the system settings are grouped. For details
refer to the Windows XP help system.
10.2 Additional Software
Risk of causing instrument unusability
The instrument is equipped with the Windows XP operating system. Additional soft-
ware can therefore be installed on the instrument. The use and installation of additional
software may impair instrument function. Thus, run only programs that Rohde &
Schwarz has tested for compatibility with the instrument software.
The drivers and programs used on the instrument under Windows XP have been adap-
ted to the instrument. Existing instrument software must always be modified using only
update software released by Rohde & Schwarz.
10.3 Windows XP Recovery and Backup Partition
The R&S SFE100 provides a backup and recovery partition. A backup of the factory
system partition (C:\) is stored per default and can be recovered in case of a system
crash.
Only R&S SFE100 models 12, 13:
In addition, backups of up to 5 firmware versions can be stored on this partition. For
example, it is possible to backup the current system partition prior to a firmware update
or to provide different system configurations for different environments. When recov-
ered, the system partition (C:/) is deleted, formatted and written newly. The data parti-
tion (D:\) is not affected.
10.3.1
Performing Backup/Recovery
The suitable procedure for performing backup/recovery depends on your R&S
SFE100
model.
●
Models 02, 03: use the procedure described in Chapter 10.3.2, "Recommended
Procedure for the R&S SFE100 Models 02, 03", on page 51.
●
Models 12, 13: use the procedure described in Chapter 10.3.3, "Windows XP
Embedded Recovery and Backup Partition Dialog", on page 51.
Windows XP Recovery and Backup Partition
To Next Page
Loading...
