Rohde & Schwarz RTE1104 - Page 1935

Remote control commands
R&S
®
RTE
1935User Manual 1326.1032.02 ─ 20
Parameters:
<RunMode> SINGle | CONTinuous
*RST: CONTinuous
WGENerator<m>:ARBGen:SAMPles?
Displays the number of samples for the arbitrary waveform.
Suffix:
<m>
.
1..2
Return values:
<NumSamples> Range: 0 to 128000000
Increment: 10
*RST: 0
Default unit: pts
Usage: Query only
WGENerator<m>:ARBGen:SELect
<ScopeSignSrc>
Selects the oscilloscope source, from which the arbitrary signal is loaded, if
WGENerator<m>:ARBGen[:SOURce] is set to SCOPe.
Suffix:
<m>
.
1..2
Parameters:
<ScopeSignSrc> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | R1 | R2 | R3 | R4 |
DIFF1 | DIFF2 | COMMON1 | COMMON2
*RST: NONE
WGENerator<m>:ARBGen:SRATe <SampleRate>
Sets the sample rate for the arbitrary waveform.
Suffix:
<m>
.
1..2
Parameters:
<SampleRate> Range: 1 to 250E+6
Increment: 10
*RST: 1E+6
Default unit: Sa/s
WGENerator<m>:ARBGen[:SOURce] <WaveformSource>
Sets the arbitrary waveform source.
Waveform generator (option R&S
RTE-B6)