Rohde & Schwarz Scope Rider RTH - Page 366

Remote Control Commands
R&S
®
Scope Rider RTH
366User Manual 1326.1578.02 ─ 12
15.6.2.4 Exporting Spectrum Analysis Results
You can export the spectrum results to a file, similar to waveforms (see Chapter 15.13,
"Documenting Results", on page 489).
SPECtrum:EXPort:NAME................................................................................................366
SPECtrum:EXPort:SAVE................................................................................................ 366
SPECtrum:EXPort:INCXvalues........................................................................................366
SPECtrum:EXPort:NAME <Name>
Defines the file name, file format and path to save the spectrum measurement results.
Parameters:
<Name> String with path and file name with extension .csv or .zip
(compressed csv).
SPECtrum:EXPort:SAVE
Saves the results of the spectrum measurement to the file specified using SPECtrum:
EXPort:NAME.
For a description of the file format see Chapter 6.2.9, "Export File Format for Spectrum
Results", on page 130.
Example:
SPECtrum:EXPort:NAME 'SpectrumResults'
SPECtrum:EXPort:SAVE
SPECtrum:EXPort:NAME?
//Result: /media/SD/Rohde-Schwarz/RTH/Export/SpectrumResults.csv
Usage: Event
SPECtrum:EXPort:INCXvalues <State>
Includes the frequency values in the stored results.
Parameters:
<State> ON | OFF
*RST: ON
15.6.3 Harmonic Mode (R&S RTH-B34)
To activate Harmonic mode, use OP HARM (see OP[:MODE] on page 298).
The following commands are only available if the Harmonic Analysis option R&S RTH-
B34 is installed.
● Configuring Harmonic Measurements...................................................................367
● Retrieving and Exporting Harmonic Results......................................................... 371
Spectrum Analysis