Rohde & Schwarz ZNB - Rear Panel R&S ZNB

Instrument Tour
R&S
®
ZNB/ZNBT
33Getting Started 1316.0062.02 ─ 26
LED controls
Above the standby toggle switch some LEDs indicate various status information:
●
[ERR]: operation state; if an error occurs, the LED lights up red; for more informa-
tion on errors and troubleshooting see the R&S ZNB/ZNBT User Manual
●
[LAN]: LAN error occurred
●
[PWR]: power state (ready/standby); see Chapter 2.8, "Standby and Ready State",
on page 15
Standby key
The standby key is located at the lower right-hand corner of the front panel. It serves
two main purposes:
●
Toggle between standby and ready state; see Chapter 2.8, "Standby and Ready
State", on page 15.
●
Shut down the instrument; see Chapter 2.7, "Starting the Analyzer and Shutting
Down", on page 14.
3.3 Rear Panel R&S ZNB
This section gives an overview of the rear panel controls and connectors of the net-
work analyzer.
1
2
12
3 4 5
8
13
11
14
7
6
9 10
15
16
17
Figure 3-3: R&S
ZNB rear view
Rear Panel R&S ZNB