Roland CAMM-1 PNC-1610 - Page 23

15
Main menu 2
Main menu 3
[Hardwire], [XON/XOFF],
[ENQ/ACK], [Software], [Hard
& Xon], [Hard & ENQ].
Select with [ENTER]
[F1] : Axis Selection
[F3] or [F4]: -0.19% —0.19%
Select with [ENTER]
[F3] : NO
[F4] : YES
[F2] : mm,step
[F2] : OFF, ON
[F4] : OFF, ON
[F4] : OFF, ON
To top menu
[F3] or [F4]:Auto,mode1,mode2
Select with [ENTER]
From main menu 1