15
Português Italiano DeutschNederlands Español Français
English
Using the LOOPER Function and Delay at the
Same Time
By taking advantage of the SOLO function, you can use the Looper
function and the delay at the same time.
Normally, you cannot use the delay when the [DELAY/LOOPER] knob is
in the LOOPER position. However, if panel settings that use the delay
are stored in the SOLO function, and you then turn SOLO on, you’ll be
able to use the delay while using the LOOPER function.
If you turn the SOLO function on while using the LOOPER function, and
then switch between JC CLEAN and LEAD, you’ll be able to record your
performance using the delay settings saved for each channel.
* Switching the delay on or o or changing the delay time is not
possible.
Copyright
* Recording, duplication, distribution, sale, lease, performance,
or broadcast of copyrighted material (musical works, visual
works, broadcasts, live performances, etc.) belonging to a
third party in part or in whole without the permission of the
copyright owner is forbidden by law.
* Do not use this unit for purposes that could infringe on a
copyright held by a third party. We assume no responsibility
whatsoever with regard to any infringements of third-party
copyrights arising through your use of this unit.
To Next Page
Loading...
Need help?
General
