Roland DDR-30 - Page 22

22
С. Copy
The Copy ‘function of the DDR-30 is useful for
when you want to use a drum sound which is
located in a different Memory area. For instance,
if the DDR-30 is in the Internal Memory mode, but
you want a drum sound on the Memory Cartridge
for making a Drum Set combination, copy the
sound you want to use from the Cartridge to the
Internal memory.
OPERATION
0) Call the Memory area (internal, Cartridge A or
B) which contains the drum sound you want
to use, then call the relevant drum sound.
(2) Push the Copy Button (D.
The Display will respond as shown below, and
the DDR-30 is now in the Copy mode.
Drum Sound Display
Memory Area Display
Copy indication
© Using the Cartridge Button @ and the Alpha
Dial © call the Memory Area where you wish
to make a combination of Drum Set.
The center of the Display will change to the
relevant Memory area.
@ By using the Patch Number Button @, call the
Patch number which is the new location for
the drum sound you have selected in the step
©.
The indication at the right of the Display changes.
lf the Cartridge memory is selected in the step @,
set the Protect Switch on the Memory Cartridge
to the OFF position.
(5) Push the Copy Button (D.
When the copy is successfully done, the Display
returns to that of the step (1).
Return the Protect Switch to the ON position.
* If you by mistake push the Copy Button (D, or
wish to cancell the Copy mode while in copy-
ing, press any of the Edit Buttons (Voice/Pitch/
Equalizer/Gate).
This Copy function is available within the same
Memory area. For example, if you wish to edit a
drum sound and keep both the original sound
and the edited one, initially copy the original
sound, which makes two of the same sounds in
memory. Then edit and write the sound. In this
way, the original sound is retained intact, the step
G) is not necessary, but if the Cartridge memory is
in use, be sure to move the position of the Protect
Switch as required.