Roland DDR-30 - Drum Sound Exploration

с. The sounds of a Drum Set
The DDR-30 features 6 drum voices (Bass, Snare
and Toms) and up to 8 different sounds per voice
{total of 48 sounds) are preprogrammed ready to
be used. However, these preprogrammed sounds
can be delicately modified to your taste and
stored in memory. (See page 12 "Edit".)
There are 8 bass drum sounds (BD-1 to BD-8), 8
snare sounds (SD-1 to SD-8), and 32 tom sounds
(four kinds of TM-1 to 8). We call those numbers
1 to 8 Patch Number.
Drum Set Drum Sound
Number Display
See Page 19
Drum Voice (BD, SD, TM1~ 4)
Patch Number (1~ 8)
When the DDR-30 is switched on, PI- 4 is
shown
at
the
right
of
the
Display,
and
as
mentioned
before, the center of the Display shows 1-11.
This means that the Drum Set 11 is ready to be
used, and the Patch number of the bass drum
sound
used
in
the
Drum
Set
11
is
BD-1
(Bass
Drum 1).
To
see
other
drum
sounds
(SD,
TM1
to
TM4)
in
the
same
Drum
Set,
take
the
following
operation.
OPERATION
(D
Press
either
side
of
the
Instrument
Button
©.
Pressing
the
upper
side
of
the
button
will
change
the
Display
like
BD
—
SD
—
TM1—
ТМ2-»
TM3—
TM4 — BD..., and pressing the lower side will
make it the other way round.
у
BD BD
4
у
50 50
^ 4 ^
Y
Ist TMI TM! INST
SELECT | n t SELECT
2 TM2 TM2 ~
4
Y
TM3 TM3
А
Y
TM4 TM4
А
* To see the drum sounds in the different Drum
Set, first assign the Drum Set number using the
Set Button @ and the Bank Button @, then take
the above procedure (1).