Roland EGX-400 - Page 100

97
7 Service Activities
7
EGX-600/400
User
Explanation
Operation
Moving the Spindle Head
The speed of movement is determined by how you press the movement buttons.
Starting and Stopping Spindle Rotation
To adjust the spindle rotating speed, you use the dial on the operation panel.
Selecting the Cutter Installation Method
1. Character cutter , Flat cutter
(
with nose unit
)
2. Character cutter , Flat cutter
(
without withoutse unit
)
3. Diamond scra
p
er
(
without withoutse unit
)
4. End mill
(
without withoutse unit
)
1. Clam
p
2. Adhesive sheet
3. Center vice
Setting the Cutting Parameters
1. S
p
indle rotatin
g
s
p
eed
2. Feed rate in the X- and Y- axis directions
3. Feed rate in the Z-axis direction
4. Cuttin
g
de
p
th
(
Z1
)
5. Amount of cut-out durin
g
feed while raised
(
Z2
)
Installation and Setu
p
the Software
EGX-600/400
User
Ex
p
lanation
Maintenance
Others
There are five kinds of settings and you can make the settings for these either on
the machine by using the menus, or by using the program.
This machine has the function that moves the spindle head directly to the back-left
position of the table (the VIEW position).
Coordinate S
y
stems
The Nose Unit
Dail
y
Care
Clean the table, bed, the s
p
indle head and the X-axis rail.
Maintenance and Ins
p
ection
O
p
tional Items
Emer
g
enc
y
Sto
p
to Ensure Safet
y
The machine immediately stops operating and quits engraving by pressing the
emergency stop switch.
Switching the Power On and Off
Menu O
p
erations
Loading Material and Setting the Reference Point for Cutting
The reference point for engraving is the location where the X- and Y-axis
coordinates are both (that is, the X- and Y-axis origin point).
Detailed Descri
p
tion of the Menus
Examples of Setting for Engraving Parameters
S
p
indle Maintenance