75
4 Adjustment
4
2
4-4 X BELT TENSION ADJUSTMENT (Referential Time : 10min.)
3
Push the X-Belt with the Tension Gauge (ST-001) at the
middle position between the X-Drive Pulley and check the
bending amount with the ruler.
Confirm that the Pressing Force matches with the Bending
Amount in reference to the next table.
X Belt
ST-001
Loosen the Screw1 and 2 and then, loosen the Nut1 and 2.
Tighten up the Nut2 so that there is no gap between the
Frame and the Nut1.
Nut2
Screw2
Nut1
Frame
Screw1
<Reference Table>
Pressing Force Bending Amount
EGX-600 720gf 10.0mm
EGX-400 720gf 7.0mm
It is possibe to adjust the X Belt Tension by
changing the position of the Nuts.
2
Remove the Rail Cover.
Rail Cover
To Next Page
Loading...
