Roland FC-100mkII - Restoring the Factory Preset Data

[Important]
3. Restoring the Factory
Preset Data
[STEP 1]
[STEP
2]
Now, the Pointe shows the current MIDI Mix status, and the FC-1 OOMK II is
in the MIDI Foot Pedal mode.
MIDI Mix
ON OFF
[]
[]
Blink
Lit
.. To change the settings, switch the unit off once, then repeat from step 1.
* What is d'isplayed for the PointtD will vary depending on whether MIDI
Mix On or Off is selected at power-up.
* If the unit is switched off in the course of making settings, those settings
which have already been made wi!! be kept in memory, while those not
yet edited remain at their previous settings .
.. When you have made settings in the MIDI Foot Pedal mode, then change
to the RRC Foot Pedal mode, the data in memory will be retained. When
you next redo settings in the MIDI Foot Pedal mode, the data in memory
will be shown in the display. (The MIDI Mix OnlOff status, however, is
determined by the setting existing at power-up.)
* In the course of making settings, MIDI messages are not transm'ltted or
received.
The Factory Preset data can be restored at any
time as follows.
While holding the Number Pedals. 1, 2 and 8 turn on the power.
Turn off the power.
Turn off the power once,
then turn it on. In this way,
the Factory Preset data will
be restored.
If you turn on the power without preSSing the pedals, the FC-1 OOMK II is set
to the RRC Foot Pedal mode and the data in the MIDI Foot Pedal mode will
be returned to the factory presets.
* For details of Factory Preset data. see "[ID Factory Preset Data" on page 19.
73