Roland FC-100mkII - RRC Foot Pedal Mode; Setup Examples

6
[3J RRC Foot Pedal Mode
1. Setup Examples
I:n"
1'·0"=
RRC IN
SIGNAL OUT
R RC OUT ::XP;
I
FC·lXJ_lI
~~\TI1
~
Select mode for connecting the FC~ 1 OOMK IT to devices equipped with an
RRC IN Socket.
This mode allows you to select patches, or use the Control Pedal and
Expression Pedal for control. Two expression pedals can be connected at
the same time.
* The expression pedal jack 2., (EXP2) cannot be used with certain types
of devices that you might wish to connect.
Ill!':
111,10
01 ~ Device featuring the RRC IN socket. such as GP-B.
Mode Selector Switch
~
laJ
lr]
.. ~.
iEil
I~I
n~~;;i
[j
1aJ
~
lDJ
~
[5J
iO.'llji~
[;f- ....
'-",~,;
r"~
I. " "j" I
[i3,~. __
-
,4~( "';'1k,!
I~'~~ . ..! ',i '"
!i'li
o 0
1"1~i-', 'hl"'~
FC-1 OOMK II
Tuner
EV-5
If- Set the position of the Mode Selector Switch 0 as explained in the
owner's manual for the dev'lce to be connected to the FC-l00MK ll.
* When connecting RRC cable, be sure to connect the IN socket on one
unit
to the OUT socket on the other unit. Do not connect IN to IN or OUT
to OUT.
* Be sure to cannot the RRC cable securely, until it locks in place,