Roland FC-100mkII - Mode Setting; Operation

2. Mode Setting
[HOW)
3. Operation
a. Patch Selection
[STEP 1)
Once the connections are completed, set the Fe-100MK II to the ARC Foot
Pedal mode.
Switch on the unit connected to the FC-100MK n while holding the Group
Pedal@) down .
... Be sure use the switch on the connected unit for turning poweF on or off.
Power On
~~
~ ~
~
..
~
,
IS:::::
r--.:.-
'0
~
[!]
~ ~ ~
~
I
Goes out
Group Pedal
When the Fe-! OOMK II is set to the RRC Foot Pedal mode, the Point tD will
go out.
* Once the Fe-100MK II is set to the RRC Foot Pedal mode, it will auto-
matically default to the RRC Foot Pedal Mode at power-up, without need
for holding the Group Pedal down .
... The Fe-100MK IT is set to the RRC Foot Pedal mode when it leaves the
manufacturer.
A Patch is a program number for an external device. It is represented by
Group, Bank and Number. There are a total of 128 Patches ava:lable for
selection.
-I< A Patch is normally displayed in the same way as on the connected device.
However, the initial display at power-up will be Group A, Bank 1 and
Number 1.
To select a Patch, do as follows.
Select a Group.
Press the Group Pedal0 to select Group A or B. The Group Indicator@} for
the selected group will light up.
Group Indicators
I
,
~~
~
~ ~
~
Ilr
~ ~
~
~
~
[]
Group Pedal
7