Roland FP-4F - Using Headphones; Adjusting the Display Brightness

17
Before You Play
Using Headphones
If you use headphones, you’ll be able to play even at night without
being heard by others nearby.
Since the FP-4F has two headphone jacks, two people can use
headphones simultaneously.
1. Connect your headphones to the PHONES jack.
If headphones are connected, sound will not be heard from the FP-4F’s
speakers.
2. Use the [VOLUME] knob (p. 14) to adjust the headphone
volume.
* To avoid damaging the cord’s internal conductive elements,
always grasp either the headset itself or the plug when handling
headphones.
* Your headphones may be damaged if the volume of a device is
already turned up when you plug them in. Minimize the volume
before you plug in the headphones.
* Excessive input will not only damage your hearing, but may also
strain the headphones. Please enjoy music at an appropriate
volume.
* Use headphones that have a stereo 1/4” phone plug.
Adjusting the Display Brightness
Here’s how to adjust the brightness of the FP-4F’s display.
1. Turn the [CONTRAST] knob to adjust the brightness of the
display.
* At times, you may notice that colors in the screen seem slightly
discolored. This is caused by a phenomenon inherent to liquid
crystal displays, and does not indicate a malfunction. By using the
[CONTRAST] knob to adjust the contrast of the screen, you can
minimize discolor.
* The contrast of the screen may be aected by the temperature.