Roland GAIA 2 - Page 54

54
Navi
Parameter Value Explanation
Cuto Velocity
Sens
-100–0–+100
Sets how much the cuto frequency changes according to how hard you play the
keys.
Set this to a “+” value to increase the cuto frequency when you play harder, and set
this to a “-” value to decrease the cuto frequency when you play harder.
Reso Velocity
Sens
-100–0–+100
Sets how much the resonance depth changes in response to how hard you play the
keys.
Set this to a “+” value to make the resonance increase when you play harder, and set
this to a “-” value to make the resonance decrease when you play harder.
FILTER ENVELOPEFILTER ENVELOPE
Depth
-63–0–+63
Species the depth of the Filter envelope.
Higher settings increase the change produced by the Filter envelope. Negative (-)
value will invert the shape of the envelope.
Velocity Sens
-100–0–+100
Use this to set how much the lter envelope changes in response to how hard you
play the keys.
Specify a positive “+” value if you want the lter envelope to apply more deeply as
you play more strongly, or a negative “-” value if you want it to apply less deeply.
Attack Time
0–255
Adjusts the time it takes for the cuto frequency to reach the maximum level from
the time that a key is pressed.
Decay Time
0–255
Adjusts the time it takes for the envelope to reach the sustain level after the cuto
frequency reaches maximum.
Sustain Level
0–255
Adjusts the cuto frequency used when the envelope has passed its attack and decay
times, before you take your nger o the key.
Release Time
0–255
Adjusts the time it takes for the cuto frequency to fall to minimum level after you
take your nger o the key.
AMPAMP
Level
0–127 Adjusts the volume of the tone.
Tone
-63–0–+63 Adjusts the tonal character of the tone.
Velocity Sens
-100–0–+100
Sets how much the volume changes according to how hard you play the keys.
Set this to a “+” value to make the volume louder when you play harder, and set this
to a “-” value to make the volume softer when you play harder.
AMP ENVELOPEAMP ENVELOPE
Attack Time
0–255
Adjusts the time it takes for the volume to reach maximum from the moment you
play a key.
Decay Time
0–255
Adjusts the time it takes for the envelope to fall to the sustain level after the volume
reaches maximum.
Sustain Level
0–255
Adjusts the volume used when the envelope has passed its attack and decay times,
before you take your nger o the key.
Release Time
0–255
Adjusts the time it takes for the volume to fall to minimum after you take your nger
o the key.
CONTROLCONTROL
Pedal Func
Species the function assigned to the pedal connected to the PEDAL jack.
OFF, MODULATION, HOLD1, EXPRESSION, VOLUME, PAN,
BEND DOWN, BEND UP, HOLD SW, MONO SW,
MFX SW, CHO LEVEL, REV LEVEL, REV SEND, BEND MODE,
ARP SW, ARP SHUFFLE, ARP DURATION, START/STOP, TAP TEMPO, TONE DOWN, TONE UP