Roland GAIA 2 - Page 66

66
Navi
MFX List
13 Inf Phaser (Innite Phaser)
A phaser that continues raising/lowering the frequency at which the sound is modulated.
L inL in
R inR in
Innite Innite
PhaserPhaser
2-Band 2-Band
EQEQ
L outL out
R outR out
Pan L
Pan R
Parameter Value Explanation
Mode
1–4 Higher values will produce a deeper phaser eect.
Speed
-100–+100
The frequency at which the sound modulation rise and falls (+: upward / -:
downward).
Resonance
0–127 Amount of feedback
Mix
0–127 Level of the phase-shifted sound
Pan
L64–63R Stereo location of the output sound
Low Gain
-15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB] Amount of boost/cut for the high-frequency range
Level
0–127 Output Level
Flanger
14 Flanger
This is a stereo anger (The left/right phases of the LFO are synchronized).
It produces a metallic resonance that rises and falls like a jet airplane taking o or landing.
A lter is provided so that you can adjust the timbre of the anged sound.
R outR out
L outL out
2-Band 2-Band
EQEQ
2-Band 2-Band
EQEQ
Balance W
Balance W
Feedback
Feedback
Balance D
Balance D
L inL in
FlangerFlanger
FlangerFlanger
R inR in
Parameter Value Explanation
Type
OFF, LPF, HPF
The lter type.
OFF: No lter is used
LPF: Cuts the frequency range above the Cuto Freq
HPF: Cuts the frequency range below the Cuto Freq
Cuto
Basic frequency of the lter
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 [Hz]
Pre Delay
0.0–100 [ms]
Adjusts the delay time from the direct sound until the anger sound is
heard.
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate
0.05–10.00 [Hz] Frequency of modulation