Roland GAIA 2 - Page 78

78
Navi
MFX List
Parameter Value Explanation
Sense
-60.0–0.0 [dB]
Adjust this value so that the sound is not made louder when distortion is
applied.
PostGain
-48.0–+12.0 [dB] Gain following distortion processing
Balance
D100:0W–D0:100W Volume balance between the dry sound (D) and eect sound (W)
Level
0–127 Output Level
33 Gt Amp Sim (Guitar Amp Simulator)
This is an eect that simulates the sound of a guitar amplier.
L inL in
R inR in
SpeakerSpeakerPre AmpPre Amp
L outL out
R outR out
Pan L
Pan R
Parameter Value Explanation
Pre Amp Sw
OFF, ON Turns the amp switch on/o.
ATyp
JC-120 This models the sound of the Roland JC-120.
CLEAN TWIN This models a Fender Twin Reverb.
MATCH DRIVE
This models the sound input to left input on a Matchless D/C-30.
A simulation of the latest tube amp widely used in styles from blues and rock.
BG LEAD
This models the lead sound of the MESA/ Boogie combo amp.
The sound of a tube amp typical of the late ’70s to ’80s.
MS1959I
This models the sound input to Input I on a Marshall 1959. This is a trebly sound
suited to hard rock.
MS1959II This models the sound input to Input II on a Marshall 1959.
MS1959I+II
A model of the Marshall 1959 sound, with inputs I and II connected in parallel. Oers
a sound with a more emphasized low-end than MS1959I.
SLDN LEAD This models a Soldano SLO-100. This is the typical sound of the eighties.
METAL 5150 This models the lead channel of a Peavey EVH 5150.
METAL LEAD This is distortion sound that is ideal for performances of heavy ris.
OD-1 This models the sound of the BOSS OD-1. This produces sweet, mild distortion.
OD-2 TURBO This is the high-gain overdrive sound of the BOSS OD-2.
DISTORTION This gives a basic, traditional distortion sound.
FUZZ A fuzz sound with rich harmonic content.
Drive
0–127 Volume and amount of distortion of the amp
Master
0–127 Volume of the entire pre-amp
Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Bass
0–127
Tone of the bass/mid/treble frequency range
Middle
0–127
Treble
0–127
Presence
0–127 Tone for the ultra-high frequency range
Bright
OFF, ON
Turning this “On” produces a sharper and brighter sound.
This is enabled only when the preamp type is “JC-120”, “CLEAN TWIN”, “MATCH
DRIVE”or “BG LEAD”.