Roland GAIA 2 - Page 77

77
Navi
MFX List
32 W Saturator (Worm Saturator)
This is a variety of saturator, and is distinctive for its warmer sound.
Balance W
Balance D
Balance D
Pre Pre
FilterFilter
OverdriveOverdrive
Post Post
Filter1-3Filter1-3
Pre Pre
FilterFilter
Low/Low/
HighHigh
Low/Low/
HighHigh
OverdriveOverdrive
Post Post
Filter1-3Filter1-3
L inL in L outL out
R outR outR inR in
Parameter Value Explanation
LowFreq
20–16000 [Hz]
An input lter (low-band audio).
Boosts/cuts the sound below the specied frequency.
LowGain
-24.0–+24.0 [dB]
An input lter (low-band audio).
This is the boost/cut amount.
Hi Slope
THRU, -12dB, -24dB
The input lter (high frequency) slope (attenuation characteristics or
amount of attenuation per octave).
THRU: No attenuation
-12 dB: Gentle
-24 dB: Steep
Hi Freq
20–16000 [Hz]
An input lter (high-frequency audio).
Boosts/cuts the sound above the specied frequency.
Pre1 Type
THRU, LPF, HPF, LSV, HSV
The types of lters available before distortion processing.
THRU: No lter is applied
LPF: A lter that passes the sound below the specied frequency
HPF: A lter that passes the sound above the specied frequency
LSV: A lter that boosts/cuts the sound below the specied frequency
HSV: A lter that boosts/cuts the sound above the specied frequency
Pre1Freq
20–16000 [Hz] Frequency at which the pre-distortion lter operates
Pre1Gain
-24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Drive
0.0–48.0 [dB] Strength of distortion
Post1 Type
THRU, LPF, HPF, LSV, HSV Type of lter 1 which follows the distortion processing
Post1Frq
20–16000 [Hz] Frequency at which post-distortion lter 1 operates
Post1Gain
-24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Post2 Type
THRU, LPF, HPF, LSV, HSV Type of lter 2 which follows the distortion processing
Post2Frq
20–16000 [Hz] Frequency at which post-distortion lter 2 operates
Post2Gain
-24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Post3 Type
THRU, LPF, HPF, BPF, PKG
The lter types available for lter 3 after distortion processing.
THRU: No lter is applied
LPF: A lter that passes the sound below the specied frequency
HPF: A lter that passes the sound above the specied frequency
BPF: A lter that passes only the specied frequency
PKG: A lter that boosts/cuts the specied frequency
Post3Frq
20–16000 [Hz] Frequency at which post-distortion lter 3 operates
Post3Gain
-24.0–+24.0 [dB] For the PKG type, the amount of boost/cut
Post3 Q
0.5–16.0 Width of the frequency range aected by the lter