Roland GAIA 2 - Page 83

83
Navi
MFX List
Delay
40 Delay
This is a stereo delay.
When Feedback Mode is CROSS:When Feedback Mode is NORMAL:
R outR out
L outL out
2-Band 2-Band
EQEQ
2-Band 2-Band
EQEQ
Balance W
Balance W
Feedback
Feedback
Balance D
Balance D
L inL in
DelayDelay
DelayDelay
R inR in
R outR out
L outL out
2-Band 2-Band
EQEQ
2-Band 2-Band
EQEQ
Balance W
Balance W
Feedback
Feedback
Balance D
Balance D
L inL in
DelayDelay
DelayDelay
R inR in
Parameter Value Explanation
Dly L Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
DL.Time
1–1300 Adjusts the time until the left delay sound is heard.
DLTime Nt
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Dly R Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
DR.Time
1–1300 Adjusts the time until the right delay sound is heard.
DRTime Nt
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Phase L
NORMAL, INVERSE
Phase of the left-right delay sound.
NORMAL: Non-inverted
INVERSE: Inverted
Phase R
NORMAL, INVERSE
Fbk Mode
NORMAL, CROSS
Selects the way in which delay sound is fed back into the eect (See the
gures above).
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the eect
(Negative values invert the phase).
HF Damp
Adjusts the frequency above which sound fed back to the eect is ltered out. If you don’t want to
lter out any high frequencies, set this parameter to BYPASS.
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000, BYPASS
[Hz]
Low Gain
-15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance
D100:0W–D0:100W Volume balance between the direct sound (D) and the delay sound (W)
Level
0–127 Output Level