Roland GAIA 2 - Page 97

97
Navi
L inL in L outL out
Feedback
Feedback
R outR outR inR in
Pitch1Pitch1
ShifterShifter
ModulationModulation
Pitch2Pitch2
ShifterShifter
ModulationModulation
Level1
Level2
Wet Level
Wet Level
Dry Level
Dry Level
ReverbReverb
Send Amount
Send Amount
Parameter Value Explanation
Low Damp
-50–+50
Adjusts the amount by which to attenuate the low-frequency portion of
the reverb.
High Damp
-50–+50
Adjusts the amount by which to attenuate the high-frequency portion of
the reverb.
Time
0.1–10.0 [sec] Adjusts the decay length of the reverb sound.
Density
1–10 Adjusts the density of the reverb sound.
Pre Delay
0–200 [msec]
Adjusts how long it takes until the reverb sound is heard, after the direct
sound plays.
Modulation
Rate
0–100 Adjusts the speed at which the reverb sound is modulated.
Modulation
Depth
0–100 Adjusts the depth to which the reverb sound is modulated.
Pitch1 Coarse
-24–+24 [semi] Adjusts the amount of pitch shift applied for pitch shift 1. (in semitones)
Pitch2 Coarse
-24–+24 [semi] Adjusts the amount of pitch shift applied for pitch shift 2. (in semitones)
Pitch1
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into pitch shift 1
(Negative values invert the phase).
Pitch2
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into pitch shift 2
(Negative values invert the phase).
Level 1
0–100 Adjusts the volume of pitch shift 1.
Level 2
0–100 Adjusts the volume of pitch shift 2.
Dry Level
0–127 Adjusts the volume of the original sound.
Wet Level
0–127 Adjusts the volume of the reverb sound.