Roland GAIA 2 - Page 98

98
Navi
02 Modulation Reverb
A reverb that inputs the modulated original sound.
L outL out
R outR out
Send Amount
ModulationModulation
Hi Cut Hi Cut
EQEQ
Lo Cut Lo Cut
EQEQ
ReverbReverb
L inL in
R inR in
Eect Level
Eect Level
Direct Level
Direct Level
Parameter Value Explanation
Modulation
Depth
0–127 Adjusts the depth of modulation.
Rate
0.05–5.00 [Hz] Adjusts the frequency of modulation.
Time
0–100 Adjusts the decay length of the reverb sound.
Low Cut
Sets the base frequency for cutting the low-frequency portion of the inputted modulated sound.
FLAT, 20, 25, 31, 40, 50, 63, 80, 100, 125, 160, 200, 250, 315, 400, 500, 630, 800 [Hz]
High Cut
Sets the base frequency for cutting the high-frequency portion of the inputted modulated sound.
630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000, 10000, 12500, FLAT (Hz)
Pre Delay
0–100
Adjusts how long it takes until the reverb sound is heard, after the direct
sound plays.
Density
0–100 Adjusts the density of the reverb sound.
Direct Level
0–127 Adjusts the volume of the original sound.
Eect Level
0–127 Adjusts the volume of the reverb sound.
03 INTEGRA-7 Reverb
A reverb built into the Roland INTEGRA-7 sound module.
Dry Level
L outL out
R outR out
Send Amount
Send Amount
INTEGRA7 INTEGRA7
ReverbReverb
L inL in
R inR in
Wet Level
Dry Level
Wet Level
Parameter Value Explanation
Char
ROOM1,
ROOM2,
HALL1,
HALL2,
PLATE
Selects the type of reverb.
PreDelay
0–100
Adjusts the delay time from when the direct sound plays until the reverb
sound is heard.
Time
0.1–10.0 [sec] Adjusts the decay length of the reverb sound.
Density
0–127 Adjusts the density of the reverb sound.