Roland GAIA 2 - Page 99

99
Navi
Parameter Value Explanation
Diusion
0–127
Adjusts how reverb density increases over time (This eect is especially
noticeable with long reverb times).
LF Damp
0–100 Adjusts the low-frequency portion of the reverb.
HF Damp
0–100 Adjusts the high-frequency portion of the reverb.
Spread
0–127 Adjusts the reverb spread.
Tone
0–127 Adjust the tonal character of the reverb.
Dry Level
0–127 Adjusts the volume of the original sound.
Wet Level
0–127 Adjusts the volume of the reverb sound.
04 SRV-2000 Reverb
A reverb that emulates the Roland SRV-2000 digital reverb.
Dry Level
L outL out
R outR out
Send Amount
ReverbReverb
3-Band 3-Band
EQEQ
L inL in
R inR in
Dry Level
Wet Level
Wet Level
Parameter Value Explanation
Selection
Selects the type of reverb oered by the Roland SRV-2000 digital reverb.
R0.3, R1.0, R7.0, R15, R22, R26, R32, R37, H15, H22, H26, H32, H37, P-B, P-A
PreDelay
0–160
Adjusts the delay time from when the direct sound plays until the reverb
sound is heard.
Time
0.1–99.0 [sec] Adjusts the decay length of the reverb sound.
HF Damp
0.05–1.00 Adjusts the high-frequency portion of the reverb.
Density
0–9 Adjusts the density of the late reverberation.
Attack Gain
0–9 Adjusts the gain of the early reections.
Attack Time
0–9 Adjusts the time of the early reections.
ER Density
0–9 Adjusts the density of the early reections.
ER Level
0–99 Adjusts the volume of the early reections.
Low Freq
0.04–1.00 [kHz] Frequency of the low range.
Low Gain
-24–+12 [dB] Gain of the low range.
Mid Freq
0.25–9.99 [kHz] Frequency of the middle range.
Mid Gain
-24–+12 [dB] Gain of the middle range.
Mid Q
0.2–9.0
Width of the middle range.
Set a higher value for Q to narrow the range to be aected.
HighFreq
0.80–9.99 [kHz] Frequency of the high range.
HighGain
-24–+12 [dB] Gain of the high range
High Q
0.2–9.0
Species the width of the high-frequency range.
Set a higher value for Q to narrow the range to be aected.
Dry Level
0–127 Adjusts the volume of the original sound.
Wet Level
0–127 Adjusts the volume of the reverb sound.