40
Chapter 3 Giving Variation to Pattern
playback will use the M-FX settings of the pattern that is
selected at that time. This means that what you hear when the
RPS plays back may be somewhat different from the original
phrase.
* If a rhythm part phrase is assigned, the Rhythm Mute settings
will be ignored during RPS playback.
* Each phrase is played back by a special RPS part 1–16 which
corresponds to each keyboard pad, but phrases assigned from a
rhythm part will be played back using the rhythm part of the
currently-selected pattern. For this reason, a different rhythm
set than that of the registered pattern may sound in some
cases. If the pattern changes so that a different rhythm set is
selected, the sounds of the rhythm set which will play the RPS
will also change.
Setting up a Part for RPS
Unlike ordinary pattern playback, RPS is played back using
RPS parts that are specially set up for RPS. Patterns assigned
to the pads [1] to [16] are used to play back the [1] to [16] RPS
parts.
The settings for these RPS parts can be altered.
* See the following sections for descriptions of the respective
parameters.
Procedure
Bring up the RPS setup screen.
1. Press the [SYSTEM] button.
2. Press the [F1 (SYS)] button.
3. Select the screen with “6 RPS PART” using the [CURSOR
(up/down)] buttons.
4. Press the [F2 (RPS)] button.
The “RPS PART” screen appears.
(Example1: PATCH screen)
(Example2: LEVEL screen)
5. Press the [F1 ( )] or [F2 ( )] buttons to select the screen
to be edited.
6. Press a keyboard pad to select the RPS part to be edited.
7. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
PATCH (RPS Part Patch)
Select the Patch of the part.
Range:
- Patches
Preset P: A001 - 128
P: B001 - 128
P: C001 - 128
P: D001 - 128
P: E001 - 128
P: F001 - 128
P: G001 - 032
User U: A001 - 128
U: B001 - 128
- Rhythm sets
Preset P: A01 - 26
P: B01 - 14
User U: 01 - 20
LEVEL (RPS Part Level)
Sets up the volume level of the part.
Range: 0–127
PAN (RPS Part Pan)
Sets up localization of the part.
Range: L64–0–63R
KEY SHIFT (RPS Part Key Shift)
Sets up transposition of the part.
Range: -12–0– +12
REV LEVEL (RPS Part Reverb Level)
Sets up the reverb strength of the part.
Range: 0–127
DLY LEVEL (RPS Part Delay Level)
Sets up the delay strength of the part.
Range: 0–127
M-FX SW (RPS M-FX switch)
Specifies whether the Multi-effect function is to be used in
the part.
Range: OFF, ON, RHY
* RHY can only be used for RPS parts using a rhythm set. If a
part is set to RHY, M-FX effects are applied according to the
settings of the respective tones in the rhythm set. Activating
M-FX for a rhythm part causes the function to be applied to all
tones.
To Next Page
Loading...
