76
Chapter 5 Creating Your Own Patterns and
Editing Patterns (Pattern Edit)
The process of editing the musical data in a pattern is called
Pattern Editing. You can modify the content of the musical
data in a pattern, or combine various patterns to create an
entirely different pattern.
CAUTION: The data in any patterns you’ve edited will be
lost if the MC-307’s power is turned off. If you wish to keep
the pattern that you created, you must use the Pattern Write
operation. (refer to Saving the Pattern (p. 83).)
Copying a Portion of a Pattern
(Copy)
A specific portion of a pattern can be copied to another
pattern.
Procedure
First, select the original pattern to be copied.
1. Press the [PTN] button.
2. Using the [VALUE] dial or the [INC/DEC] buttons,
select the original pattern to be copied.
Invoke the screen for executing Copy.
3. Press the [F3 (EDIT)] button.
4. Press the [F2 (TRACK EDIT)] button.
The screen for selecting Pattern Edit appears.
5. Press the [CURSOR (left, right)] button to invoke the
screen displaying “COPY.”
6. Press the [F1 (COPY)] button.
The setup screen for the source appears.
Specify the pattern range to be copied.
7. Select the part to be copied by pressing the relevant
PART button, [R], [1] to [7].
8. Move the cursor to “FROM” by pressing the [CURSOR]
buttons, and then select the measure at the beginning of
the portion of the pattern to be copied using the
[VALUE] dial or the [INC/DEC] buttons.
* If SETUP is selected, the setup parameter for the pattern is
also copied.
9. Move the cursor to “FOR” by pressing the [CURSOR]
buttons, and then specify the number of measures to be
copied from the beginning of the portion of the pattern to
be copied using the [VALUE] dial or the [INC/DEC]
buttons.
* If you selected SETUP in Step 9 and only want to copy the
setup parameter, select “-” with FOR.
10.Move the cursor to “STATUS” by pressing the
[CURSOR] buttons, and then select the data to be copied
from the copy source data using the [VALUE] dial or the
[INC/DEC] buttons.
11.Press the [F4 (OK)] button.
The setup screen for the destination appears.
Enter the settings for the copy destination pattern.
12.To select the copy destination part, press the relevant
PART button, [R], [1] to [7] or [RHYTHM PART VIEW].
If you specified two or more parts as the copy source,
this step is not required. (They will be copied to the same
copy destination parts as the copy source parts.)
* By pressing the [RHYTHM PART VIEW] button you can
specify the MUTE CTRL PART.
13.Move the cursor to “PTN” by pressing the [CURSOR]
buttons, and then select the pattern number to which the
part is to be copied using the [VALUE] dial or the [INC/
DEC] buttons.
14.Move the cursor to “MEAS” by pressing the [CURSOR]
buttons, and then select the measure number at the
beginning of copy destination using the [VALUE] dial or
the [INC/DEC] buttons.
15.Move the cursor to “MODE” by pressing the [CURSOR]
buttons, and then select the copying mode using the
[VALUE] dial or the [INC/DEC] buttons.
To copy the portion of a pattern with the data written at
the destination left intact, select “MIX.” To copy it with
that data overwritten, select “REPL.”
16.Move the cursor to “TIMES” by pressing the [CURSOR]
buttons, and then select the number of copying
operations using the [VALUE] dial or the [INC/DEC]
buttons.
Now, execute copying.
17.Press the [F4 (OK)] button.
A screen asking you whether or not you want to execute
copying appears.
To Next Page
Loading...
