Roland Groovebox MC-307 - Page 50

50
Chapter 4 Setting Effects
4. Overdrive (Distort the Sound Mildly)
This simulates the soft distortion that occurs when you raise
the gain of a vacuum tube amp. The effect also contains an
amp simulator, and produces the natural distortion that is
created by sounds played through a guitar amp. It is suitable
for use with guitar and synth-bass sounds.
Available Settings:
- INPUT LEVEL [CTRL 1]
Adjusts the level of the input signal.
Range: 0–127
- DRIVE [CTRL 2]
Adjusts the depth of distortion. This will also affect the
volume.
Range: 0–127
- AMP TYPE [CTRL 3]
Selection for the type of guitar amp.
Range
SMALL:small amp
BUILTIN:built-in type amp
2STACK:large double amp stack
3STACK:large triple amp stack
- OUTPUT PAN [CTRL 4]
Specifies the stereo location of the sound that is output
from the Overdrive effect.
Range: L64–63R
- OUTPUT LEVEL [CTRL 5]
Specifies the output volume from the Overdrive effect.
Range: 0–127
5. Distortion
(Distort the Sound Severely)
This effect produces a more severe distortion than the
Overdrive effect. It also contains an amp simulator, and
produces the natural sound of a guitar amp.
Available Settings:
- INPUT LEVEL [CTRL 1]
Adjusts the level of the input signal.
Range: 0–127
- DRIVE [CTRL 2]
Adjusts the depth of distortion. This will also affect the
volume.
Range: 0–127
- AMP TYPE [CTRL 3]
Determines the type of guitar amp.
SMALL:small amp
BUILTIN:built-in type amp
2STACK:large double amp stack
3STACK:large triple amp stack
- OUTPUT PAN [CTRL 4]
Specifies the stereo location of the sound that is output
from the Distortion effect.
Range: L64–63R
- OUTPUT LEVEL [CTRL 5]
Specifies the output volume from the Distortion effect.
Range: 0–127