Roland GT-100 - Using Send;Return

Creating Sounds (Eects)
29
Quick Guide Overview Outputting Sound Eects Saving
Pedal Settings
System MIDI/USB Appendices
Using Send/Return
You can connect an external eects processor between the SEND
jack and RETURN jack, and use it as one of the GT-100’s eects
processors.
The sound that is input to SEND/RETURN within the eect chain will
be output to the SEND jack. The sound that is input via the RETURN
jack will be input to SEND/RETURN within the eect chain.
1. Press the [EFFECT] button.
2. Use knob [4] to select “SEND/RETURN.”
3. Use knobs [5]–[8] to make settings.
Con-
troller
Parameter Value Explanation
[5] MODE
NORMAL
The input to SEND/RETURN within the
eect chain will be output to the SEND
jack, and the input from the RETURN jack
will be output following SEND/RETURN.
Use this setting if you want to connect an
external eects processor in series within
the GT-100’s eect chain.
SEND RETURN
DIRECT
MIX
The input to SEND/RETURN within the
eect chain will be output to the SEND
jack, and the input from the RETURN
jack and the input to SEND/RETURN (the
direct sound) will be mixed and output
following SEND/RETURN.
Use this when you want to mix the
GT-100’s eects sounds together with the
sound with the external eects device
applied to it.
SEND RETURN
BRANCH
OUT
The input to SEND/RETURN within the
eect chain will be output to the SEND
jack. The input from the RETURN jack will
be ignored.
For example, by placing SEND/RETURN in
the GT-100’s eect chain in front of reverb
or delay, this allows you to use the SEND
jack as a direct out.
SEND
[7]
SEND
LEVEL
0–200
Adjusts the volume of the output to the
external eects device.
[8]
RETURN
LEVEL
0–200
Adjusts the volume of the input from the
external eects device.