Roland HP702 - Convenient Functions; Saving Piano Setups; Loading Piano Setups

22
° Convenient Functions
Loading/Saving Piano Setups
You can save your own piano settings in a USB ash drive, or load
them into the other digital piano.
* Settings can be loaded only into another piano of the same
model.
Settings that are saved
Setting Page
Speaker volume p. 6
Headphone volume p. 7
Key Touch p. 16
Ambience p. 16
Headphones 3D
Ambience
p. 16
Brilliance p. 16
Setting Page
Master Tuning p. 16
Temperament p. 17
Temperament Key p. 17
Hammer Response p. 17
Piano Tone settings p. 18
Volume Limit p. 26
Saving Piano Settings (Piano Setup Export)
1. Connect your USB ash drive to the USB Memory
port.
2. Press the [ ] button.
The [ ] button is lit, and the piano is in function mode.
3. Turn the [ ] knob to access “Piano Setup Export”
screen, and then press the [
] knob.
The Piano Setup Export screen appears.
4. Rename the piano settings.
Select the character which
you want to change
Turn the [ ] knob
Change the character
Press the [
] knob (conrm)
/
Turn the [ ] knob (change the
character)
/
Press the [ ] knob (back)
Insert one character
Press the [
s
] button
Delete one character
Press the [
7
] button
5. Turn the [ ] knob to select the
(
at the right
edge of the screen, and then press the [ ] knob to
conrm.
The settings are saved.
NOTE
Never disconnect the USB ash drive or turn o the power while
the screen indicates “Executing...”
6. Press the [ ] button to exit function mode.
The [ ] button goes dark.
Loading Piano Settings (Piano Setup Import)
1. Connect your USB ash drive to the USB Memory
port.
2. Press the [ ] button.
The [ ] button is lit, and the piano is in function mode.
3. Turn the [ ] knob to access “Piano Setup Import”
screen, and then press the [ ] knob.
The Piano Setup Import screen appears.
4. Turn the [ ] knob to select the piano settings that
you want to load.
5. Press the [ ] knob to conrm.
A conrmation message appears.
If you decide to cancel, press the [ ] button.
6. Turn the [ ] knob to select “Yes,” and press the [ ]
knob to conrm.
The settings are loaded.
NOTE
Never turn o the power or disconnect the USB ash drive while
the screen indicates “Executing...”
7. Press the [ ] button to exit function mode.
The [ ] button goes dark.