Roland JUNO-106 - Page 28

[Note
5]
MIDI
Function (Application of
Sys-
tem
Exclusive Communication)
In paraiie! setup of two
Juno
-
106's,
if the
MIDI Function Switch is set to Hi,
the master
Juno can perfectly
control
the
slave one. That
is, Information of each
parameter of
the
patch
selected in the master Juno
will
be
sent to the
slave
Juno
by means of
Exciussive Message.
The information here includes
the setting of
each control and switch. Here, the
Patch
Prog-
ram number information
is not transmitted to
the slave Juno, but its tone
color will turn out
exactly the same as
the master Juno's, be-
cause of the
parameter information sent from
the
master Juno.
Changing patches
in the
master Juno
does
not alter the Program Number currently
shown
in
the
Display on the slave Juno,
only
dots will light
indicating that Exclusive Mes-
sage
has been
received.
*
Even if the slave Juno is set to
Manual
mode, dots lighting is seen in the
Display
when the
Exclusive message is received.
Also if any of the controls or switches under
a red belt of the
master
Juno is
moved even
slightly, corresponding
parameter
Informa-
tion is transmitted to
the slave Juno,
by
means of
Exclusive
Message,
therefore
the
slave Juno is perfectly
controlled
by it, re-
gardless of its own panel setting.
MIDI
OUT
MIDI FUNCTION ill
MIDI
IN
JUNO106
JUNO106
Master
Slave
•
Exciussive Message is a
special kind of
message that allows several
informations
to be
communicated between two {or
more)
Juno-106's, or the Juno-106
and
a
computer.
This Exciussive Message
is av-
ailable
only when the MIDI
Function Switch
is set to III. in the setup with a
keyboard
other than the
Juno-106 or a keyboard re-
corder, set the MIDI
Function
to !
or II which
does not allow
communication
by
Excius-
sive Message.