Roland juno-ds61 - MFX;Chorus;Reverb Parameters; Lo-Fi Radio and Telephone Effects; Phonograph and Pitch Shifter Effects

54
MFX/Chorus/Reverb Parameters
58: LOFI RADIO
In addition to a Lo-Fi eect, this eect also generates radio noise.
R in
R out
L in
L out
Lo-Fi
Lo-Fi
Radio
2-Band
EQ
2-Band
EQ
Parameter Value Explanation
LoFi Type 1–9
Degrades the sound quality. The sound quality
grows poorer as this value is increased.
Post Filter Type
Type of lter
OFF No lter is used
LPF Cuts the frequency range above the Cuto.
HPF Cuts the frequency range below the Cuto.
Post Filter Cuto 200–8000[Hz] Basic frequency of the Post Filter
Radio Detune # 0–127
Simulates the tuning noise of a radio.
As this value is raised, the tuning drifts further.
Radio Noise Level # 0–127 Volume of the radio noise
Low Gain -15–+15[dB] Gain of the low range
High Gain -15–+15[dB] Gain of the high range
Balance # D100:0W–D0:100W
Volume balance between the direct sound (D)
and the eect sound (W)
Level 0–127 Output level
59: TELEPHONE
This eect produces a mued sound, like that heard through a telephone.
L in
R in
L out
R out
Telephone
Telephone
Parameter Value Explanation
Voice Quality # 0–15 Audio quality of the telephone voice
Treble -15–+15[dB] Bandwidth of the telephone voice
Balance # D100:0W–D0:100W
Volume balance between the direct sound (D)
and the eect sound (W)
Level 0–127 Output level
60: PHONOGRAPH
Simulates a sound recorded on an analog record and played back on a record player.
This eect also simulates the various types of noise that are typical of a record, and
even the rotational irregularities of an old turntable.
L in
R in
Phonograph
Phonograph
L out
R out
Balance W
Balance W
Balance D
Balance D
Parameter Value Explanation
Signal Distortion 0–127 Depth of distortion
Frequency Range 0–127
Frequency response of the playback system
Decreasing this value will produce the impression
of an old system with a poor frequency response.
Disc Type LP, EP, SP
Rotational speed of the turntable
This will aect the frequency of the scratch noise.
Scratch Noise Level 0–127 Amount of noise due to scratches on the record
Dust Noise Level 0–127 Volume of noise due to dust on the record
Hiss Noise Level 0–127 Volume of continuous “hiss”
Total Noise Level # 0–127 Volume of overall noise
Wow 0–127 Depth of long-cycle rotational irregularity
Flutter 0–127 Depth of short-cycle rotational irregularity
Random 0–127 Depth of indenite-cycle rotational irregularity
Total Wow/Flutter # 0–127 Depth of overall rotational irregularity
Balance #
D100:0W–
D0:100W
Volume balance between the direct sound (D)
and the eect sound (W)
Level 0–127 Output level
61: PITCH SHIFTER
A stereo pitch shifter.
L in
R in
Pitch Shifter
Pitch Shifter
L out
R out
2-Band EQ
2-Band EQ
Parameter Value Explanation
Coarse #1 -24–+12[semi]
Adjusts the pitch of the pitch shifted sound in
semitone steps.
Fine #1 -100–+100[cent]
Adjusts the pitch of the pitch shifted sound in
2-cent steps.
Delay Time 0–1300[msec], note
Adjusts the delay time from the direct sound
until the pitch shifted sound is heard.
Feedback # -98–+98[%]
Adjusts the proportion of the pitch shifted
sound that is fed back into the eect. Negative (-)
settings will invert the phase.
Low Gain -15–+15[dB] Gain of the low range
High Gain -15–+15[dB] Gain of the high range
Balance # D100:0W–D0:100W
Volume balance between the direct sound (D)
and the pitch shifted sound (W)
Level 0–127 Output level
62: 2VOI PCH SHIFTER
Shifts the pitch of the original sound. This 2-voice pitch shifter has two pitch shifters,
and can add two pitch shifted sounds to the original sound.
L in
R in
L out
R out
Level 1
Balance W
Balance D
Balance W
Balance D
Level 2
Pan 2 R
Pan 1 L
Pan 1 R
Pan 2 L
2Voice
Pitch Shifter
2-Band
EQ
2-Band
EQ
Parameter Value Explanation
Pitch1 Coarse #1 -24–+12[semi]
Adjusts the pitch of Pitch Shift 1 in semitone
steps.
Pitch1 Fine #1 -100–+100[cent]
Adjusts the pitch of Pitch Shift Pitch 1 in 2-cent
steps.
Pitch1 Delay 0–1300[msec], note
Adjusts the delay time from the direct sound
until the Pitch Shift 1 sound is heard.
Pitch1 Feedback # -98–+98[%]
Adjusts the proportion of the pitch shifted
sound that is fed back into the eect. Negative (-)
settings will invert the phase.
Pitch1 Pan # L64–63R Stereo location of the Pitch Shift 1 sound
Pitch1 Level 0–127 Volume of the Pitch Shift1 sound
Pitch2 Coarse #2 -24–+12[semi]
Settings of the Pitch Shift 2 sound.
The parameters are the same as for the Pitch
Shift 1 sound.
Pitch2 Fine #2 -100–+100[cent]
Pitch2 Delay 0–1300[msec], note
Pitch2 Feedback # -98–+98[%]
Pitch2 Pan # L64–63R
Pitch2 Level 0–127
Low Gain -15–+15[dB] Gain of the low range
High Gain -15–+15[dB] Gain of the high range
Balance # D100:0W–D0:100W
Volume balance between the direct sound (D)
and the pitch shifted sound (W)
Level 0–127 Output level
3
3
3
3
3