Roland LEC-300A - Correcting for Misalignment in Bidirectional Printing

Correcting for Misalignment in Bidirectional Printing
20
2. Changes to the User’s Manual2. Changes to the User’s Manual

[To conrm again / adjust again]
Press
to select [YES].
Press
to enable the setting.
The test pattern of bidirectional correction is output again. Go back to
the procedure
 and set again.
[To go to the next after correction is completed]
Press
to select [DONE].
Press
to enable the setting.
Correcting for Misalignment in Bidirectional Printing
Models : LEC-300/300A/330/540, LEJ-640
Articles in the User’s Manual
* Replace the information on the following articles of the table of contents with the information found in this document.
LEC-300
“Correcting for Misalignment in Bidirectional Printing”
LEC-300A
LEC-330
LEC-540
LEJ-640
Procedure
1. Press .
2. Press several times to display the gure on the below.
MENU
ADJUST BI-DIR
3. Press .
ADJUST BI-DIR
TEST PRINT
4. Press .
A test pattern is printed.
5. When printing is completed, press in this order.
6. Press to select 1 or 2.
SIMPLE SETTING
１： ０
２： ０
REDO ADJ. ?
YES [DONE]