Roland LEC-300A - Method for Switching the Ink Type

Switching the Ink Type
23
2. Changes to the User’s Manual2. Changes to the User’s Manual
Method for Switching the Ink Type
1. Draining Ink Remaining Inside the Unit
Important
Insert each color ink cartridge into the slot labeled with the matching color. If you insert the wrong cartridges, the color inks
may be mixed. Be careful not to insert the wrong cartridges. Contact your authorized Roland DG Corp. dealer or us, if you
inserted the wrong cartridges and the color inks were mixed.
1. Press .
2. Press several times until the screen shown below appears.
MENU
SUB MENU
3. Press .
4. Press several times until the screen shown below appears.
SUB MENU
INK CONTROL
5. Press in this order until the screen shown below appears.
INK CONTROL
PUMP UP
6. Press .
7. Thereafter, follow the on-screen instructions to carry out the operations.
After cleaning has nished, the sub power is automatically switched o.
memo
The error message “CANCELED FOR MOTOR PROTECTION” may display to prevent damage to the machine due to the
overheating of pump motor.
In this case, allow the machine to stand for approximately 10 minutes before resuming operation.
Press any key other than the sub power switch to cancel the error message.