132
Appendix
Appendix
fig.AlgoMTPDly.eps
This is a mono-in, stereo-out twelve-stage tap delay.
Delay
DELAY UNIT
Specifies the units for delay
Value: msec, Meter, Feet, Frame (24, 25, 29.97, 30),
Note)
DELAY 1–12 TIME
Time from the original sound until the delay is heard
Value: 0.0–2700 m
DELAY 1–12 LEVEL
Level of the delay sound
Value: -INF–+6.0 dB
DELAY 1–12 PAN
Panning of the delay sound
Value: L63-C-R6
FEEDBACK TIME (Feedback time)
Time until the delayed sound is returned to the input of the
delay
Value: 0.0–2700 ms
FEEDBACK LEVEL (Feedback level)
Amount of delayed sound returned to the input of the delay.
The feedback level specifies the amount of sound that is
returned. Increasing this setting will increase the number of
delay repetitions.
Value: 0–100
LO FREQ DAMP GAIN
Low-frequency attenuation of the delay sound
Value: -36.0–0.0 dB
LO FREQ DAMP FREQ
Frequency at which the low-frequency region of the delay
sound begins to be attenuated
Value: 20 Hz–2.00 kHz
HI FREQ DAMP GAIN
High-frequency attenuation of the delay sound
Value: -36.0–0.0 dB
HI FREQ DAMP FREQ
Frequency at which the high-frequency region of the delay
sound begins to be attenuated
Value: 200 Hz–20.00 kHz
WET (Wet Level)
Level of the delay sound
Value: -INF–+6.0 dB
DRY (Dry Level)
Level of the original sound
Value: -INF–+6.0 dB
M.TAP DELAY (Multi Tap Delay)
Input R
Output R
Multi Tap Delay
Pan 1
Pan 2
Pan 12
FEEDBACK
LEVEL
DRY
DRY
Input L
Output L
DPF
M-200i_e.book 132 ページ ２０１３年１月１６日 水曜日 午後４時９分
To Next Page
Loading...
