Roland M-200i V-mixer - About Geqs; Geq Function Screen; Geq Screen

71
Effects,GEQ,External effects
Effects,GEQ,External effects
About GEQs
The M-200i has four internal GEQs (GEQ1 through 4) separately
from the stereo effects.
GEQ1 through 4 can be inserted into CH1 through 32, MAIN L and
R, AUX1 through 8, and MTX1 through 4.
You use the GEQ screen to operate GEQ1 through 4.
You can also change the effect type for FX1 through 4 to
monaural GEQ.
1.
In the top panel's DISPLAY section, press the [GEQ]
button.
The GEQ screen is displayed.
You can use the up and down cursor buttons to change GEQ1
through 4.
Selection of the input source and output destination is the same
as at the EFFECTS screen.
For information on how to select the input source and output
destination, refer to “Effect input/output settings” (p. 66).
You can store or recall settings of GEQs using effect library.
Effect library operations are performed at the FX LIBRARY screen.
1.
Access the GEQ screen.
2.
Move the cursor to the LIB button for the desired GEQ
among "GEQ 1-4" and press [ENTER].
For information on operations at the FX LIBRARY screen, refer to
the "Using the effect library" section (P.70).
You can only choose GEQ as a effect type on GEQ 1-4.
Y
1.
Access the GEQ screen.
2.
Press [FUNC] to access the GEQ FUNCTION screen.
The operations available at the GEQ FUNCTION screen are as
follows:
GEQ screen
Accessing the FX LIBRARY screen
GEQ FUNCTION screen
GEQ1-4 SOURCE
This sets the insert channel for the specified GEQ.
BYPASS GEQ 1-4 This turns bypass on/off for the specified GEQ.
When these are on, the input signal will be “thru-ed”
to the output.
GEQ 1/2 (3/4)
LINK
This links the parameters between GEQ 1 and 2 (or
GEQ 3 and 4).
M-200i_e.book 71 ページ ２０１３年１月１６日 水曜日 午後４時９分