Roland M-200i V-mixer - LIMITER Screen

53
COMPRESSOR/LIMITER screen
COMPRESSOR/LIMITER screen
Limiters are provided on each AUX1 through 8, MTX1 through 4,
and MAIN L and R.
ON button
This turns the LIMITER on/off.
IN meter
This shows the input level of the limiter. For stereo-linked
channels, two meters (L and R) are shown.
GR meter
This shows the amount of gain reduction for the limiter.
OUT meter
This shows the output level of the limiter. For stereo-linked
channels, two meters (L and R) are shown.
Parameter
This sets the parameter for the limiter.
THRESH knob
This adjusts the threshold level in a range of -40.0 dB to 0.0
dB.
ATTACK knob
This adjusts the ATTACK time in a range of 0.0 ms to 800.0
ms.
This is the time from when the input signal exceeds the
threshold level until the limiter effect reaches its maximum.
KNEE knob
This adjusts the KNEE in a range of HARD or SOFT1 to SOFT9
(ten steps). The way in which the limiter is applied to the
region near the threshold level can be adjusted between
steep (HARD) and gentle (SOFT9).
RELEASE knob
This adjusts the RELEASE time in a range of 0 ms to 8000 ms.
This is the time from when the input signal falls below the
threshold level until the limiter effect disappears.
1. In the fader module section, press [SEL] to select the
desired channel.
2.
In the CHANNEL EDIT section, press [COMP].
When COMPRESSOR is selected as the compressor type,
COMPRESSOR is displayed in the title bar. For information on
how change the type, refer to “Changing between
COMPRESSOR/LIMITER” (p. 52).
LIMITER screen
1
2
3
4
5
1
2
3
4
Accessing the LIMITER screen
M-200i_e.book 53 ページ ２０１３年１月１６日 水曜日 午後４時９分