14
Introduction
Introduction
1.
As shown in the illustration, fit the power cord hook over
the power cord.
fig.cord-hook1.eps
When installing in a Rack, the M-200i should be used only
with the optional rackmount angle brackets, RA-10U.
RA-10U Included items
• Rackmount angles (two)
• Screws (eight)
• Hex key
* Assembly requires a Phillips screwdriver (not included).
How to Attach
1.
Loosen the screws (16 Phillips-head screws), and remove
side panels.
2.
Fasten the rack mount angles with the 8 Phillips-head
screws contained in the RA-10U.
Attaching the power cord hook
When installing in a Rack
M-200i_e.book 14 ページ ２０１３年１月１６日 水曜日 午後４時９分
To Next Page
Loading...
