73
Effects,GEQ,External effects
Effects,GEQ,External effects
1.
Access the desired GEQ EDIT FUNCTION screen.
2.
Move the cursor to the GEQ ON FADER and press [ENTER].
You can accomplish GEQ operations using the faders on the
top panel.
The range of corresponding faders is displayed on the
screen.
3.
Press the layer buttons in the LAYER section (p. 18) to
select the band to manipulate.
The bands that correspond to the layer buttons are as
indicated below.
You can change the range of operation by selecting the GEQ
fader with left and right cursor.
[MUTE] buttons flash for faders whose position is anything other
than 0.0dB. Pressing a flashing [MUTE] resets its fader to the
0.0dB position.
When the “0.5dB STEP“ setting you can make at the GEQ
FUNCTION screen is turned on, you can operate the GEQ faders
in steps of 0.5 dB.
Controlling a GEQ using the top-panel
faders
USER1 layer button
Disabled
USER2 layer button Disabled
AUX/MTX/DCA layer button 630Hz-20kHz
CH17-32 layer button 125-4.0kHz
CH1-16 layer button 20-630Hz
M-200i_e.book 73 ページ ２０１３年１月１６日 水曜日 午後４時９分
To Next Page
Loading...
