Roland M-200i V-mixer - Saving and Recalling Scenes

75
Scene memory
Scene memory
1.
Access the SCENE screen.
2. From the scene list, select the desired scene and press
[ENTER]. A popup appears.
3.
Move the cursor to the RECALL and press [ENTER].
A confirmation message is displayed, prompting you to
confirm the scene-recall operation.
4.
Pressing [ENTER] recalls the data.
Pressing [EXIT] cancels the operation.
If “SCENE/LIB RECALL“ in the CONFIRMATION section of User
Preference (p. 94) is not in effect, no confirmation message is
displayed in step 3.
Noise may occur when you recall a scene, but this is not a
malfunction.
Recalling a blank scene is not possible.
1.
Access the SCENE screen.
2.
From the scene list, select the desired scene and press
[ENTER]. A popup appears.
3.
Move the cursor to the STORE and press [ENTER].
The SCENE STORE screen is displayed. Edit the name of the
scene memory.
For information on how to edit the name, refer to “Editing a
name” (p. 33).
4.
When you've finished editing the name, press [ENTER].
A message prompting you to confirm the operation is
displayed.
5.
Pressing [ENTER] stores the data.
Pressing [EXIT] cancels the operation.
If “SCENE/LIB STORE“ in the CONFIRMATION section of User
Preference (p. 94) is not in effect, no confirmation message is
displayed in step 4.
A scene for which [L] is displayed for STATUS is locked and
cannot be stored. Unlocking is performed at the SCENE screen.
For details, refer to “Locking/unlocking a scene” (p. 76).
Recalling a scene memory to the mixer
parameters (recall)
Saving mixer parameters in a scene
memory (store)
M-200i_e.book 75 ページ ２０１３年１月１６日 水曜日 午後４時９分