11
Owner’s Manual
Turning the RD-2000 On
Once everything is properly connected, be sure to follow the
procedure below to turn on their power. If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure.
1. Turn down the volume of the RD-2000.
Also completely turn down the volume of any connected external
devices.
2. Press the [
L
] switch.
The unit is turned on, and the display’s backlighting comes on.
3. Turn on the power to connected external devices.
4. Adjust the volume of the connected external devices.
5. Adjust the RD-2000’s volume.
Turning O the Power
1. Turn down the volume of the RD-2000.
Also completely turn down the volume of any connected external
devices.
2. Turn o the power to connected external devices.
3. Press the [
L
] switch.
The unit is turned o.
* Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal
and does not indicate a malfunction.
* If you need to turn o the power completely, rst turn o the
unit, then unplug the power cord from the power outlet. Refer to
“To completely turn o power to the unit, pull out the plug
from the outlet” (p. 2).
If you don’t want the power to turn o
automatically, change the “Auto O” setting to “O”
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used for
playing music, or its buttons or controls were operated (Auto O
function).
If you do not want the power to be turned o automatically, disengage
the Auto O function.
NOTE
5 When the power is turned o, any settings you were editing will
be lost. You must save settings that you want to keep.
5 To restore power, turn the power on again.
Changing the auto o setting
1. In the MENU screen, select “SYSTEM” and press the [ENTER]
button.
The System screen appears.
2. Choose “Auto O,” and change the setting.
Parameter
[
K
] [
J
]
Value
[DEC] [INC]
Explanation
Auto O
O
The power will not turn o
automatically.
30 min
The power will automatically turn o
if no operation is performed for 30
minutes.
240 min (default)
The power will automatically turn o
if no operation is performed for 240
minutes (four hours).
3. To store the auto o setting, press the [WRITE] button in the
System screen.
NOTE
When the auto o function turns the power o, the settings that you
were editing will be lost. If there are settings that you want to keep,
you should save them beforehand. For details, refer to “Saving the
Sound Settings in a Program (Program Write)” (p. 23) and “Saving the
system settings” (p. 26).
To Turn the Power On Again After It Was Turned O by”Auto-O”
If the auto o function turned the power o, turn o the [
L
] switch
and then turn the power on again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
