Roland RD-600 - Selecting Setup Memories

28
Selecting a Setup Memory
Let’s select setup memory 14.
@
ed fa a
INTERNAL TONE CATEGORY
= 1 = 2 E.FIANO ORGAN: STRINGS C=] BASS/LEAD CLAV/MALLET
TENA. TONE TEST
Peete es
1. Make sure that the [EDIT] button indicator is dark.
If it is lit, press the [EDIT] button to make the indicator go dark.
E PART SELECT
EO LOWER {SER UPPER LOWER -HES— UPPER
fag PAGE =»
DEC/NO INC/YES
2.Simultaneously press the GROUP [A] button and [B] button.
All of the Group / Category / Variation button indicators will blink orange.
3. Press CATEGORY [PIANO 1] / VARIATION [4] to make their indicators light.
Setup memory 14 has now been selected.
About the factory settings for setup memories 11-18
11: The same settings as when the power is turned on for the first time. You can play a piano
sound by itself.
12: Two types of piano sound are layered, with their pitch slightly detuned to simulate a
honky-tonk piano.
13: A tone with a strong attack is layered with a sustained sound.
14: Two pad-type tones are layered to create a thick ensemble.
15: The keyboard is split, with piano in the upper part and bass in the lower part. You can
play different tones in the right hand and left hand.
16: The keyboard is split, with a lead-type tone assigned to the upper part and strings to the
lower part. You can play backing with the left hand and a solo with the right hand.
17: The keyboard is split, with bass assigned to the upper part and a drum set to the lower
part.
18: The Transmit Ch. of the TX UPPER/LOWER parts is set to INT (p.40). This setting is con-
venient when you wish to record on a sequencer.