Roland RD-600 - Local Part Parameters; MIDI Transmit Channel and Part Assignment; Keyboard Range (Zoning) Settings

nel
Local
part
parameters
Local part settings include the following parameters.
When an INT part is selected When a TX part is selected
Part Assign Transmit Ch.
Key Range Key Range
Transpose Transpose
Velocity Sens Velocity Sens
Velocity Max Velocity Max
DamperPedalSw DamperPedalSw
FC1i Pedal Sw FC1 Pedal Sw
FC2 Pedal Sw FC2 Pedal Sw
Mod Lever Sw Mod Lever Sw
Bend Lever Sw Bend Lever Sw
Setting the MIDI transmit channel
(Transmit
Ch.)
.......0000000000eeeee-Default
value:
TX
UPPER=1,
TX
LOWER=2
In order to play an external MIDI sound source from the RD-600, you will first need to “set the
MIDI channels.”
Unless the transmitting device (RD-600) and the receiving device (the external MIDI sound
source) are set to the same MIDI channel, there will be no sound.
Also, the RD-600 transmits MIDI messages from the TX local parts, but receives MIDI messages
for the internal parts. When you are recording your own playing on an external sequencer, you
will need to set the same channels for the TX parts as for internal parts which are assigned to
the INT parts. If this is not done, the recorded performance will not be played back correctly.
If this parameter is set to INT, the TX part will transmit MIDI messages on the same channel as
the internal part that is assigned to the INT part, making it easy for you to record / playback on
a sequencer.
In other words, the TX UPPER part will transmit the messages of the INT UPPER part from
MIDI OUT, and the TX LOWER part will transmit the messages of the INT LOWER part.
* This parameter exists only for the TX part (UPPER / LOWER).
* For MIDI channels of the receiving device, refer to the owner’s manual for the external MIDI sound
source that is connected.
* For sequencer recording/playback, refer to p.47.
Este he: ibe: vet Range of values: 1-16 (Ch), INT
TH Ur ith
Assigning an internal part to a local part
(Part Assign).......Default value: INT UPPER=Part 1, INT LOWER=Part 2
Specify which internal part will be controlled by the INT part.
Pressing the [INC/YES] button will increase the part number of the internal part that is
assigned, and pressing the [DEC/ NO] button will decrease it.
* This parameter exists only for the INT part (UPPER / LOWER).
bPart Assign Range of values: 1-16 (Part)
IHT LePart 2
Shifting the keyboard range (Zoning) (Key Range)
In normal playing condition, pressing the split button will divide the keyboard at the split
point, allowing a single keyboard to play different Tones.
The Key range setting allows you to divide the keyboard in greater detail.
40