Roland RD-600 - Keyboard Range (Zoning) Settings

Does not sound Key Range Does not sound
(Sound)
* This setting will have no effect unless the [SPLIT] button is pressed in normal playing mode.
* When you set the Split Point, the Key Range will be set automatically.
The keyboard is used to make the setting.
(Procedure 1)
1.Select the local part for which you wish to make settings.
2.Press the PAGE [ « ][ = ] buttons to move the cursor (the blinking underline) to the lower limit
of the key range.
Lkes Range : Range of values: AO-C8
IHT Ue C4-e CF
3.Press a note on the keyboard. The note number of the key you pressed will appear in the dis-
play (the display will blink).
4. If the displayed note is correct, press the [INC/ YES] button (the blinking display will change to
steadily lit). To cancel the note that you input, press the [DEC/NO] button.
5.Press the PAGE [ ~ ][ > ] buttons to move the cursor to the upper limit of the key range.
Lies Range a Range of values: AO-C8
IHT
Ue
Ch-®
CP
6. Press a note on the keyboard. The note number of the key you pressed will appear in the dis-
play (the display will blink).
* It is not possible to specify a key that is lower than the key specified as the lower limit.
7.1f the displayed note is correct, press the [INC/ YES] button (the blinking display will change to
steadily lit). To cancel the note that you input, press the [DEC/ NO] button.
(Procedure 2)
1.Select the local part for which you wish to make settings.
2. Press notes to indicate the desired upper limit and lower limit.
Key Range
Hold down Press the highest key
3.The upper limit and lower limit note numbers will appear in the display (the display will be
ptieiat Zh
4. If the display notes are correct, press the [INC/ YES] button (the blinking display will change to
steadily lit). To cancel the input, press the [DEC/NO] button.
41