Roland RD-600 - Page 57

RATE/SENS: Release Time
This sets the interval from the time when the signal
drops below the threshold level until the time that the
effect ceases.
DEPTH/LEVEL: Threshold
This sets the level at which the Limiter effect appears.
Input signals above the specified level are com-
pressed.
11. HEXA-CHORUS
This is a six-phase chorus (six layered chorused
sounds) which adds depth and spaciousness to the
sound.
RATE/SENS: Rate
This sets the speed of the modulation.
DEPTH/LEVEL: Depth
This sets the depth of the modulation.
12. TREMOLO-CHORUS
This is a chorus which adds a tremolo effect (cyclic
modulation of the volume).
RATE/SENS: Tremolo Rate
This sets the speed of modulation of the Tremolo
effect.
DEPTH/LEVEL: Balance
This sets the balance for the levels of the original
sound and the effect sound (chorus sound).
13. SPACE-D
This is a multiple chorus with two-phase modulation
applied in stereo. It does not produce a sense of mod-
ulation, but creates a transparent-sounding chorus
effect.
RATE/SENS: Rate
This sets the speed of the modulation.
DEPTH/LEVEL: Depth
This sets the depth of the modulation.
14. STEREO-CHORUS
This is a chorus with full stereo output.
RATE/SENS: Rate
This sets the speed of the modulation.
DEPTH/LEVEL: Depth
This sets the depth of the modulation.
15. STEREO-FLANGER
This is a Flanger with full stereo output (the left and
right LFOs are in phase). The depth of the effect can
be increased to obtain a sound that moves up and
down, like a jet taking off or landing.
RATE/SENS: Rate
This sets the speed of the modulation.
DEPTH/LEVEL: Depth
This sets the depth of the modulation.
16. STEP-FLANGER
This is a flanger in which the pitch of the flanger
changes in steps.
RATE/SENS: Step Rate
This sets the cycle for the changes in pitch.
DEPTH/LEVEL: Depth
This sets the depth of the flanger modulation.
17. STEREO-DELAY
This is a full-stereo delay.
RATE/SENS: Delay Time
This adjusts the time from the original sound until
when the delay sound is heard.
DEPTH/LEVEL: Feedback Level
This adjusts the proportion of the effect sound that is
once again returned to the input.
18. MODULATION-DELAY
This effect adds modulation to the delayed sound.
RATE/SENS: Rate
This sets the speed of the modulation.
DEPTH/LEVEL: Depth
This sets the depth of the modulation.
19. TRIPLE-TAP-DELAY
This delay sets different delay times for the three
directions of center (C) / left (L) / and right (R).
RATE/SENS: Delay Time
This adjusts the time from the original sound until
when the delay sound is heard.
DEPTH/LEVEL: Feedback Level
This adjusts the proportion of the effect sound that is
once again returned to the input.
20. QUADRUPLE-TAP-DELAY
This delay uses four independent delay times.
RATE/SENS: Delay Time
This adjusts the time from the original sound until
when the delay sound is heard.
DEPTH/LEVEL: Feedback Level
This adjusts the proportion of the effect sound that is
once again returned to the input.
21. TIME-CONTROL-DELAY
This lets you control the delay time in real-time.
When you change the delay time, the pitch and delay
time of the delayed sound will change. If you assign
foot controller 1/2 to control EFX: Rate/Sns or EFX:
Dept/Lvl (p.50), you can use an expression pedal or
pedal switch connected to the FC1 or FC2 jack to con-
trol the delay time or feedback level.
57