Roland RD-600 - Quick Access Shortcuts

10
11
12
13
By using shortcuts you can jump directly to the desired parameter of Edit mode.
Select the INT UPPER part and jump to the EFX Type/Level parameter
[EDIT]+EFX [UPPER] (When you repeat this operation, Type and Level will alternate.)
Select the INT LOWER part and jump to the EFX Type/Level parameter
[EDIT]+EFX [LOWER] (When you repeat this operation, Type and Level will alternate.)
Jump to the Reverb Amount of the selected Tone or reverb settings group
[EDIT]+[REVERB] (When you repeat this operation, the individual parameters will alternate.)
Jump to the Chorus Amount of the selected Tone or chorus settings group
[EDIT]+[CHORUS] (When you repeat this operation, the individual parameters will alternate.)
Jump to the Key Range of the selected local part
{EDIT]+[SPLIT]
Jump to the Transpose setting of the selected local part, or to the Coarse Tune
setting of the selected Tone
[EDIT]+[TRANSPOSE] (When you repeat this operation, Transpose and Coarse Tune will alter-
nate.)
Jump to the Mod Lever Sw of the selected local part
Hold down the [EDIT] button and move the bend lever away from yourself
Jump to the Bend Lever Sw of the selected local part, or to the BendRangeUp
setting of the selected Tone
Hold down the [EDIT] button and move the bend lever toward the right.
(If you continue holding down the [EDIT] button and once again move the bend lever to the
right, Bend Lever Sw and BendRangeUp will alternate.)
* Ifa TX part ts selected, you will jump to the Bend Lever Sw or to the Bend Range.
Jump to the Bend Lever Sw of the selected local part, or to the BendRangeDown
of the selected Tone
Hold down the [EDIT] button and move the bend lever toward the left.
(If you continue holding down the [EDIT] button and once again move the bend lever to the
left, Bend Lever Sw and BendRangeDown will alternate.)
* Ifa TX part is selected, you will jump to the Bend Lever Sw or to the Bend Range.
Jump to the DamperPedalSw of the selected local part, or to DamperPolarity
Hold down the [EDIT] and press a connected damper pedal.
(When you repeat this operation, DamperPedalSw and DamperPolarity will alternate.)
Jump to the FC1 Pedal Sw of the selected local part, or to FC1 Assign (function
assign for foot controller 1)
Hold down the [EDIT] button and operate the pedal that is connected to FC1.
(When you repeat this operation, FC1 Pedal Sw and FC1 Assign will alternate.)
Jump to the FC2 Pedal Sw of the selected local part, or to FC2 Assign (function
assign for foot controller 2)
Hold down the [EDIT] button and operate the pedal that is connected to FC2.
(When you repeat this operation, FC2 Pedal Sw and FC2 Assign will alternate.)
Jump to Write SETUP (saving a setup memory)
In Edit mode, simultaneously press both Group buttons [A] and [B].
63